Remote Maintenance by telnet
63
2
set
Use the "set" command to set the pro-
tocol information display "active" or
"inactive".
❖ View settings
The following command displays
protocol information (active/inac-
tive).
msh> set ipv4
msh> set ipv6
msh> set appletalk
msh> set netware
msh> set smb
msh> set protocol
• When protocol is specified, in-
formation about TCP/IP, Ap-
pleTalk, Netware, and SMB
appears.
msh> set lpr
msh> set lpr6
msh> set ftp
msh> set ftp6
msh> set rsh
msh> set rsh6
msh> set diprint
msh> set diprint6
msh> set web
msh> set snmp
msh> set ssl
msh> set ssl6
msh> set nrs
msh> set rfu
msh> set rfu6
msh> set ipp
msh> set ipp6
msh> set http
msh> set http6
msh> set bonjour
msh> set nbt
msh> set ssdp
msh> set ssh
msh> set sftp
msh> set sftp6
❖ Configuration
• Enter “up”to enable protocol,
and enter “down” to disable
protocol.
You can set the protocol to "active"
or "inactive".
msh> set ipv4 {up | down}
• If you disable IPv4, you cannot
use remote access after logging
off. If you did this by mistake,
you can use the control panel to
enable remote access via IPv4.
• Disabling IPv4 also disables lpr,
ftp, rsh, diprint, web, snmp, ssl,
ipp, http, bonjour, and sftp.
msh> set ipv6 {up | down}
• If you disable IPv6, you cannot
use remote access after logging
off. If you did this by mistake,
you can use the control panel to
enable remote access via IPv6.
• Disabling IPv6 also disables
lpr6, ftp6, rsh6, diprint6, ssl6,
ipp6, http6, and sftp6.
msh> set appletalk {up |
down}
msh> set netware {up | down}
msh> set smb {up | down}
msh> set lpr {up | down}
msh> set lpr6 {up | down}
msh> set ftp {up | down}
msh> set ftp6 {up | down}
msh> set rsh {up | down}
msh> set rsh6 {up | down}
msh> set diprint {up | down}
msh> set diprint6 {up | down}
Commentaires sur ces manuels