Ricoh Network Data Protection Unit Type C Manuel d'utilisateur télécharger pdf (Page 58)

Installing Options

E Adjust the notch of the Memory Unit to the slot, and then insert vertical-

ly.

F Press the Memory Unit down until it clicks into place.

G When replacing the default SDRAM module, press down the levers on

both sides ( ) to remove the default module ( ).

Install a new SDRAM module.

❒ To increase memory capacity to the maximum of 512 MB, remove the de-

fault SDRAM module, and then install two 256 MB SDRAM modules.

H When installing other options on the controller board, do not close the

controller board, but go to the steps for installing the option.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 107 108

Pas de commentaire

Ricoh Network Data Protection Unit Type C Manuel d'utilisateur Page 58