Ricoh GX7000 Guide de l'utilisateur télécharger pdf (Page 95)

• Ink smearing can be caused by environmental conditions (such as high humidity) and the type

of image being printed (such as ink-heavy images).If smearing occurs, set [Print Quality] to

[Quality priority] or [Speed priority]. This may stop the ink smearing.

• Roller marks might appear on printed images.

• If paper is fed from the bypass tray, roller marks might appear on the printed image.

• To ensure water and oil resistance, leave the printed sheet to dry for about a day.

• Some print images can cause the paper to curl, which creates patchy print. If this happens, set

[Print Quality] to [Quality priority].

• Only one sided printing is possible.

• When using these sheets, see the instructions supplied with them.

Envelopes

• Up to 20 envelopes can be loaded in tray 1.

• If the envelopes bulge, flatten them.

• Load envelopes carefully, because the printable area depends on the orientation.

• Set the lever to the rear position before printing.

Thick paper

• Thick paper is heavier than 157 g/m

(42 lb.).

• You can insert paper with weights up to 255 g/m

(60 lb.) into the bypass tray.

• Insert paper with the print side face up into the bypass tray.

Cautions to Observe After Printing

Depending on the paper type, the ink may take a while to dry. Before handling, make sure printed

sheets have fully dried. otherwise, the ink may smudge.

• The ink may smear depending on the type of image. If this happens, set the envelope selector to the

rear position .

Non-compatible Paper

Check if the paper is compatible.

Do not use paper that is:

•

wrinkled, folded, or damaged

• wavy at the ends

• curled

• absorbent

• dry and conducive to static buildup

Paper

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 271 272

Pas de commentaire

Ricoh GX7000 Guide de l'utilisateur Page 95