Ricoh 2000 Manuel d'utilisateur télécharger pdf (Page 95)

Manual Dial

Pick up the optional handset or the handset of the external telephone and dial.

When the line is connected and you hear a high-pitched tone, press the {Start}

key to send your fax document. If, on the other hand, you hear a voice at the oth-

er end, continue conversation as normal.

Important

❒ The optional handset or an external telephone is required.

❒ This function is not available for Internet Fax and IP-Fax.

A Place the original, and then select the scan settings you require.

B Pick up the handset.

You will hear a dial tone.

C Dial.

To specify a destination using a Quick Dial key, see “Using the Quick Dial Keys”.

The machine immediately dials the destination.

If you make a mistake, replace the handset, and then try again from step

D When the line is connected and you hear a high-pitched tone, press the

{Start} key to send your fax document.

If you hear a voice, tell the receiver that you want to send them a fax docu-

ment (ask them to switch to facsimile mode).

The transmission starts.

E Replace the handset.

If you want to cancel a transmission, press the {Clear/Stop} key, and then re-

move the originals.

After transmission, the standby display appears.

Note

❒ When the operation switch is off, even if the main power switch is on, you

cannot operate this machine using only the optional handset or the hand-

set of the external telephone. You must first press the operation switch to

turn on the machine.

Reference

p.58 “Using the Quick Dial Keys”

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 203 204

Pas de commentaire

Ricoh 2000 Manuel d'utilisateur Page 95